Rob Cosman's Marking Gauge Cutters without Rods
Gallery
Full Description
Customer Reviews
We offer replacement marking gauge cutters without rods for all of our marking gauges. While you will probably never wear out a marking gauge cutter, it is common to chip or break a cutter through use or by dropping your marking gauge.
Our marking gauge cutters are designed to work with either a Cosmanized or a Rob Cosman marking gauge rod but they may fit any marking gauge rod that attaches the cutter with a 6-32 inch or 4mm threaded screww, but we cannot guarentee that.
All of our cutters come pre-sharpened. We sharpen these on a CBN abbrasive wheel.
We offer four different sizes of replacement marking gauge cutters without rods. Each cutter is a different size and has different bevel angles so that you can use the right cutter for the right job. See below for details:
-
3/8 inch cutter with rod - 40 degree bevel (Best used for cleaning out mortises and sockets). Cutter only fits a 6-32 inch threaded screw.
-
1/2 inch cutter with rod - 25 degree bevel (Best used as a general purpose cutter in soft or hard woods). Cutter fits both a 6/32 inch threaded screw and a 4 mm threaded screw.
-
7/16 inch cutter with rod - 20 degree bevel (Best used for marking in soft woods). Cutter fits a 6/32 inch threaded screw or a 4 mm threaded screw.
-
5/8 inch cutter with rod - 35 degree bevel (Best use when marking for angled dovetails). Cutter fits a 6/32 inch threaded screw or a 4 mm threaded screw.