Replacement blades for Rob's Dovetail Marking Knife.

Straight Blade:

• The straight blade is designed for tracing tails onto the pin-board using traditional marking techniques.

• Radius tip “track’s” in the end grain.

• Wide at the blade tip for better registration against the tail.

Regular Saw-Tooth Blade:

• Designed specifically for use with Rob's dovetail transfer technique.

• Made of the same blade material as my regular dovetail saw, .024 inch thick kerf.

• Regular saw tooth blade has 22 TPI so it goes into the kerf easily.

• Allows you to "saw" a starting kerf in the pin-board.

3/4 Saw-Tooth Blade:

• Designed specifically for use with Rob's dovetail transfer technique.

• Made of the same blade material as my 3/4 dovetail saw, .019 inch thick kerf.

• 3/4 saw tooth blade has 22 TPI so it goes into the kerf easily.

• Allows you to "saw" a starting kerf in the pin-board.

.025 inch Kerf Saw-Tooth Blade

• Designed specifically for use with Rob's dovetail transfer technique.

• Leaves a .025 inch thick kerf.

• Works with any dovetail saw that has a .025 inch - .026 inch thick kerf.

• DOES NOT work with any Rob Cosman Saw